J-HOP 650R-R, J-HOP 650R-L, J-HOP 650RX-R,
J-HOP 650RX-L

Product Data		Click on icons below for an explanation of terms
	Clamping Force	280 - 650 ton

	Swing Angle	0° - 180° (Selection from 0°, 45°, 90°, 135°, 180°)

	Adjustable Stroke	Yes

	Adjustable Chuck Waiting Position	Yes

	Controller	GII-type

Sprue picker for vertical moulding machine. This robot is applicable for runner extraction out of small-size moulding machine.
Compact design for space-saving. It offers enough horizontal moving distance, 1380mm maximum from mould center to sprue runner release point, even though the overall robot width is approximately half of the conventional model.
Stable high-speed operation with servo motor. Equipped with a servo-driven joint arm, it saves overhang floor space from a moulding machine given to a take-out robot body. That enables crusher setting close to the rear-side of the moulding machine. Additionally, it offers reduction of take-out cycle time.

Model		J-HOP 650R-R	J-HOP 650R-L	J-HOP 650RX-R	J-HOP 650RX-L
Stroke	Entry (mm)	Stroke 680 / Release position 13801 (1680)2
	Descent (mm)	90
	Swing	Selection from 0, 45, 90, 135 , 180
Air Consumption Litre(Normal)/Cycle		2.6


Maximum Weigh Capacity		1Kg
Robot Weight		40Kg

*1 Standard --- rotating radius 350mm / *2 (vvv)dimension --- rotating radius 500mm

Option	Explanation
X Specification	When moulded products are released onto a conveyor or a chute, the chuck unit rotates 90 degrees to release the products without damaging them.
Special color	The main body, frame covers, control box, etc. can be painted with the color specified by customers.
Three (3) position safety switch on controller	Valve operation is possible only while the operator is holding this switch in the center position.
Mount for horizontal extraction (Stand-alone type)	This is a stand-alone mount on which a take-out robot is fixed when there is no space for the take-out robot on the moulding machine's bed.




Mount for horizontal extraction (On moulding machine type)	This mount is to be set on the moulding machine's bed when a take-out robot is unable to be installed on the bed surface directly.