SXA-10II

Product Data		Click on icons below for an explanation of terms
	Clamping Force	10 - 15 ton

	Number of Servo Axes	2 Axes

	Controller	E-touch Lite

Stabilizes the quality of delicate products. These days, much higher quality is required for delicate products such as connectors. Extraction of moulded products after moulding process determines the quality of such products. The SXA-10II interlocks with super small moulding machines with which product take-out and installation of a take-out robot have been considered difficult. This robot allows you to raise the ratio of good products and achieve stable moulding.
Installed beside a moulding machine. There is less vibration from a take-out robot to a moulding machine because the robot is not installed onto the stationary platen of the moulding machine.
User-friendly controller "E-touch Lite". SXA-10II is equipped with user-friendly controller "E-touch Lite" that has 7.5 inch colored LCD touch panel with quick response of picture conversion. Additionally, this controller has user-programming software "Lead Through Teaching" as a standard function.

Model	SXA-10II
Maximum Power Consumption	AC200V 2.3A(Suck-up type blow with out)
Traverse Stroke (mm)	400mm(standard),550mm(Extended Type)
Kick Stroke (mm)	200mm(standard),300mm(Extended Type)
Air Consumption Litre (Normal) / Cycle	18.0 l(Normal)/cycle(Suction Ejector type) 9.0 l(Normal)/cycle(Suction blow type) 3.0 l(Normal)/cycle(adsorption type)
Maximum Payload (kg)	Less than 1Kg

Option	Explanation
Suck-up type end-of-arm tool	This robot sucks up a whole portion of a miniature product that has only small surface for adsorption. 1 to 8 cavities of products can be extracted using this equipment.
Camera inspection device	This device allows you to check remaining products inside the mould or to perform other image inspections.
Product stock by cavity	Molded products can be accumulated and sorted according to cavity.